Panasonic KX-TD816NZ - Manual (Page 180)

5.3 Operation
180
DECT Portable Station
5.3.2 Receiving Calls
When you receive a call, the DECT portable station (PS) rings or vibrates, and the outside line
number or extension number of the receiving call will appear on the display.
• You can hang up also by pressing the TALK button or placing the PS on the charger.
• If you set "INT/CO" or "INT ONLY" to the Automatic Answer Mode (PS Programming) and
connect the headset, your phone will answer incoming calls automatically.
If you leave your PS unattended with the headset connected, the following problems will
occur.
a) The PS will answer calls and the calling party will be charged even though you are not
there to take the call.
b) Depending on the line, even if the calling party disconnects the call, the DECT line may
remain connected until you disconnect the call manually or the battery expires.
The PBX trunk may also remain connected to the network.
Please note the following:
a) Please set "INT/CO" or "INT ONLY" to the Automatic Answer Mode only when
necessary.
b) If you are using the "INT/CO" or "INT ONLY" setting in the Automatic Answer Mode and
you take off the headset, please pull the the headset jack out.
• To select the vibration mode
Press the Volume Control button until "
VIBRATION CALL " is displayed. This button also
changes the ringer volume which is indicated by the number of asterisks on the display.
• If the PS is on the charger, just lift up the PS (Quick Answering).
• If a headset is connected to the PS,
you can select to answer a call without lifting your PS (Automatic Answer Mode).
Customising Your PS
• 5.4.2 PS Programming – To change the initial settings
Quick Answering Mode Set
Select to answer calls by just lifting the ringing PS off the charger.
Automatic Answer Mode Set
Select the answering mode when using the headset.
PS
Talk.
OR
Press TALK or
flashing CO. Press CANCEL.
C
F1-F3
(CO)