Panasonic KX-TD816NZ - Manual (Page 22)

2.1 Before Operating the Telephones
22
Operation
When You Use a Panasonic Proprietary Telephone
If you use a Panasonic proprietary telephone and the Console, they may have some of the useful
function buttons listed below. These buttons make operations simple. The illustrations may differ from
the buttons on your telephone.
ANSWER: Used to answer an
incoming call. Function: Located beside the display.
Used to perform the displayed function
or operation.
AUTO ANSWER / MUTE: Used to
receive an incoming intercom call in
the hands-free mode or mute the
microphone during a conversation. HOLD: Used to place a call on hold.
AUTO DIAL / STORE: Used for System
Speed Dialling or storing programme
changes. INTERCOM: Used to make or receive
an intercom call.
Call Forwarding / Do Not Disturb:
Used to perform Call Forwarding or Do
Not Disturb or change the display of an
outside call information. Jog Dial: Used to adjust the volume
and the display contrast or select
desired items for each function.
CO: Used to make or receive an
outside call. A Loop-CO button
supports all lines. Pressing this button
seizes an idle line automatically.
(Button assignment is required.)
Also used as the desired function
buttons. (Button assignment is
required.)
(Only the CO "number" (e.g. 1, 2) may
be shown on some telephones.) MESSAGE: Used to leave a message
waiting indication or call back the party
who left the message waiting
indication.
MONITOR: Used for hands-free
dialling. You can monitor the party's
voice hands-free.
Conference: Used to establish a three-
party conversation. PAUSE: Used to insert a pause during
dialling. Used as the PROGRAM
button if it is not equipped.
DSS: Used to access the extension.
(Only the "S" may be shown on some
telephones.) PROGRAM: Used to enter and exit the
Station Programming mode.
FLASH: Used to disconnect the current
call and make another call without
hanging up. Or used to send a flash
signal to the Central Office or another
connected PBX, if you programme
"EFA"( External Feature Access ) to
the FLASH button by system
programming. Programmable Feature: Located on
the upper part of the CO button or on
the Console.
Assigns the desired
button and used to access the stored
function. Mostly used as a one-touch
dialling button.
(Only the "F and number" may be
shown on some telephones.)
ANSWER
AUTO ANSWER
MUTE
HOLD
AUTO DIAL
STORE INTERCOM
FWD/DND
(CO)
MESSAGE
MONITOR
CONF
PAUSE
(DSS) PROGRAM
FLASH
(PF)