Panasonic 3000 - Manual (Page 13)

GETTING TO KNOW YOUR MACHINE
GE
TTING TO
KNOW
Y
O
UR
MACHI
NE
13
Setup as SMTP mail server
To install the DP-2500/3000 as SMTP mail server, the following network parameters need to be programmed
on your network and on the DP-2500/3000.
• IP Address of the DNS Server (if not available, see Note 2)
• IP Address of the DP-2500/3000
• Subnet Mask of the DP-2500/3000
• Name or IP Address of the Default SMTP mail server
• IP Address of the Default Router
• Email Address of the DP-2500/3000 (see Note 1)
• Host Name
Email Transmission (from the DP-2500/3000 to a PC) (see Note 1) (see Note 2) (see Note 3)
Email reception (from a PC to the DP-2500/3000)
NOTE
1. To function as SMTP mail server, the DP-2500/3000’s email address must include its unique Host name within
your company domain. This unique Host name must be registered within your network’s DNS (Domain Name
System) server. Example: [email protected]
2. By default the machine requires the IP Address of the DNS Server and prompts you to enter the SMTP Server
Name. If the DNS Server is not available, change the Fax Parameter No. 161 (DNS SERVER) to "1:Invalid".
Then the machine will prompt you to enter the IP Address of the SMTP Server.
3. Dynamic Host Configuration Protocol (DHCP) is not supported.
[email protected]
SMTP01.panasonic.com
(SMTP Mail Server)
POP02.panasonic.com
(POP Server)
(Router)
[email protected]
SMTP
POP3
[email protected]
SMTP01.panasonic.com
(SMTP Mail Server)
(Router)
[email protected]
SMTP
Pre Installation Information