Panasonic KX-HCM280A User Manual
Page 58
Operating Instructions
58
•
Set up the IPsec policy as the following.
9.
Access the camera (see page 11).
•
If you can access the camera, the IPsec setup is complete.
Note
•
In IPsec communications, "IPsec" is displayed on the Top page or the
Single Camera page.
•
If you cannot communicate using IPsec, see 2.7 IPsec in the
Troubleshooting section of the Installation/Troubleshooting.
•
See the Panasonic Network Camera support website at
http://panasonic.co.jp/pcc/products/en/netwkcam/ for the IPsec
features.
Phase 2
Mode
Quick mode
PFS
Specifies either of Off, D-H Group 1 or D-
H Group 2.
Cipher Algorithm
Select from DES-CBC, 3DES-CBC,
AES-CBC (128, 192, 256 bits) or NULL.
(Multiple selections are available.)
Message-Digest
Algorithm
HMAC-MD5-96, HMAC-SHA-1-96
Lifetime
Specifies by 28800 s (Byte setting is not
supported.)
*1
The camera does not support aggressive mode.
Items
Settings
Protocol
ANY
Source Network
Network address and subnet mask on the LAN side of the
VPN router
Source IP address
A global address on the WAN side of the VPN router
Destination Network
A global address of the camera
Destination IP address
A global address of the camera
IKE Items
Settings