Pentair INTELLIFLO VS-3050 - Manual (Page 12)

4
IntelliFlo VS-3050 Installation and User’s Guide
Controls and LEDs
Speed 1, Speed 2, Speed 3, and Speed 4 button/LED: Press one of the speed buttons to select the
desired preset pump speed. The pump preset speeds are: Speed 1 (750 RPM), Speed 2 (1500 RPM),
Speed 3 (2350 RPM), and Speed 4 (3110 RPM). The speed button LED is on when the selected button
is pressed. If the pump is running and the Up/Down button is used to adjust the speed, the selected speed
LEDs will go off. For more about using the speed buttons, see page 5.
Up/Down button: While the pump is running, press the Up or Down button to increase or decrease the
pump speed. To save the new pump speed, press any one of the four speed buttons for three seconds to
assign the speed to the selected button (the LED be on). Four adjusted pump speeds can be assigned to the
speed buttons. When the pump is using an adjusted speed and the pump is powered down, the next time
the pump is powered up the pump will use the same speed. For more about using the Up/Down button, see
page 5.
Start button/LED: Starts the pump using a selected or adjusted speed. This LED is on when the pump is
running.
Stop button: Press this button to stop the pump.
On LED: This green power LED is on when IntelliFlo is powered up.
Alarm LED: This LED is on when an error condition occurs. This green LED will flash a certain number of
times indicating a specific error condition. For the alarm LED flash sequence, refer to “Alarm and Warning
LED Sequence,” on page 29.
IntelliFlo VS-3050 Operator Control Panel
The IntelliFlo VS-3050 operator control panel provides manual speed controls for the pump. There are four
preset speed buttons that can be selected. The Up and Down button is used to adjust the pump speed. The
selected speed can be saved and assigned to one of the speed buttons.
IntelliFlo ®
1
2
3
4
5
6
3 4
1
2
5
6