Pentair INTELLIFLO VS-3050 - Manual (Page 16)

8
IntelliFlo VS-3050 Installation and User’s Guide
Priming the pump for the first time, or after service
(Continued)
Priming the Pump
• Release all pressure from filter, pump, and piping system; see the filter owner’s manual.
• In a flooded suction system (water source higher than pump), the IntelliFlo VS-3050 pump will
prime itself when suction and discharge valves are opened.
• If the IntelliFlo pump is not in a flooded suction system, unscrew and remove lid cover; fill the and
pump with water.
• Do not lubricate the trap cover o-ring. The original equipment o-ring contains a permanent internal
lubricant.
NOTICE: If you replace the o-ring with a non-internally lubricated o-ring, you may need to apply a silicone
based lubricant.
• Clean and inspect o-ring; reinstall on trap cover.
• Replace trap cover on trap; turn clockwise to tighten cover.
NOTICE: Tighten the pump lid by hand only (no wrenches)!
Pump should prime now. Priming time will depend on vertical length of suction lift and horizontal length of
suction piping. If pump does not prime, make sure that all valves are open, suction pipe end is under water,
pump suction is below water level, and that there are no leaks in suction pipe.
To prime the IntelliFlo pump:
1. Turn the pump clamp and lid in a counterclockwise direction until it stops
and remove them.
2. Fill the pump strainer pot with water.
3. Reinstall the pump clamp and lid onto the strainer pot. The pump is now
ready to prime.
4. Make sure all electrical connections are clean and tight.
5. Open the air release valve on the filter, and stand clear of the filter.
6. Switch the IntelliFlo pump on at the circuit breaker. Ensure that the
green power light is on.
7. Press the Speed 1 button to select the pump speed of 750 RPM.
8. Press the Start button to start the pump. Use the Up/Down button to increase the speed as necessary
to prime the pump.
9. When water comes out of the air release valve, close the valve. The system should now be circulating water
back to the pool without air bubbles showing in either the hair and lint pot or at the pool return fittings.
10. Use the Up/Down button to adjust the operating speed as desired.
Top view