Pentair INTELLIFLO VS-3050 - Manual (Page 13)

5
IntelliFlo VS-3050 Installation and User’s Guide
Section 2
Operating IntelliFlo VS-3050
This section describes how to use the IntelliFlo VS-3050 pump control panel.
Setting the pump preset speed
IntelliFlo operates using one of the preset speeds. Use the speed buttons to select the preset speeds.
To set the pump speed
1. Ensure that the pump is powered on and the green power LED is on.
2. Press the desired speed button (1- 4) for less than three seconds to select the preset pump speed.
When the selected speed button is pressed, the LED is on. The pump preset buttons and speeds are:
Speed 1 button - 750 RPM
Speed 2 button - 1500 RPM
Speed 3 button - 2350 RPM
Speed 4 button - 3110 RPM
3. Press the Start button to start the pump using the selected speed if necessary.
Adjusting the pump speed
IntelliFlo can be adjusted to run at any speed between 400 RPM and 3450 RPM.
To adjust the pump speed
1. Ensure that the pump is powered on and the green power LED is on.
2. Press the Start button to start the pump if the pump is not running.
3. Press the UP/Down button to increase or decrease the pump speed.
• 10 RPM increments: Press and quickly release the Up/Down button to
increase or decrease the speed in 10 RPM increments.
• 20 RPM increments: Press and hold the Up/Down button to continuously
increase or decrease the pump speed.
4. Saving an adjusted speed: To save the newly adjusted pump speed, press and
hold the desired speed buttons to assign the current speed. Four new pump
speeds can be assigned to Speed buttons (1-4).
5. Press the Speed button that is assigned to the adjusted speed.
Up/Down button