Panasonic DMC-LZ8 User Manual
Page 24
24
VQT1L86
Preparation
m/ft
Set the unit to display available recording
range
m: displayed in meter
q
ft: displayed in feet
SCENE MENU ( P52 , 55 )
Setup the screen in advanced scene mode
or scene mode
OFF: Displays scene currently
selected
q
AUTO: Displays scene selection
screen
DIAL DISPLAY
Set whether the mode dial position is
displayed on screen when turning the
mode dial.
OFF
q
ON
Initializing the built-in memory or
a card.
FORMAT
Usually, it is not necessary to format the
built-in memory and the card. Format them
when the message [BUILT-IN MEMORY
ERROR] or [MEMORY CARD ERROR]
appears. Use batteries with suffi cient
power when formatting.
Once formatting has been completed,
all data including protected pictures
will be deleted. Make sure not to
delete them before formatting
When the card is not inserted, built-in
memory can be formatted. When the card
is inserted, the card can be formatted.
Do not turn the camera off during
formatting.
It may take longer to format the built-in
•
•
•
•
memory than the card. (Max. about 15 sec.)
You cannot format an SD Memory Card
or an SDHC Memory Card when the
card’s Write-Protect switch set to [LOCK].
If the card has been formatted on a PC or
other equipment, format it on the camera
again.
If the built-in memory or the card cannot
be formatted, consult your nearest
Service Center.
For USA assistance, please call:
1-800-211-PANA (7262) or, contact us via the web at:
http://www.panasonic.com/contactinfo
For Canadian assistance, please call:
1-800-99-LUMIX (1-800-995-8649) or send e-mail to:
[email protected]
{
LANGUAGE
Set to the language on the menu screen
from the following languages.
q
[ENGLISH]: English
[DEUTSCH]: German
[FRANÇAIS]:
French
[ESPAÑOL]: Spanish
[ITALIANO]: Italian
[繁體中文]: Chinese (Traditional)*
[
]:
Japanese
* Available in Canada only
When you set to other language by
mistake, select [
{
] from the menu icons
to set the desired language.
•
•
•
•
Press [
] to display menu, enter the setup menu [ ] and select the item.
( P20 )
The setting marked “q” means it is the initial setting.