Planet Technology FGSW-2620VM User Manual
Page 13
FGSW-2620VM User’s Manual
port without having to power down the Switch. As the Figure 2-8 appears.
Figure 2-8
Plug-in the SFP transceiver
Approved PLANET SFP Transceivers
PLANET switches support both single mode and multi mode SFP transceiver. The following list of approved PLANET
SFP transceivers is correct at the time of publication:
■
MGB-SX SFP (1000BASE-SX SFP transceiver )
■
MGB-LX SFP (1000BASE-LX SFP transceiver )
■
MFB-FX SFP (100Base-FX SFP transceiver - 2Km)
■
MFB-F20 SFP (100Base-FX SFP transceiver -20Km)
#
Note
:
It recommends using PLANET SFPs on the Switch. If you insert a SFP transceiver that is not
supported, the Switch will not recognize it.
Before connect the other switches, workstation or Media Converter.
1. Make sure both side of the SFP transceiver are with the same media type, for example: 1000Base-SX to
1000Base-SX, 1000Bas-LX to 1000Base-LX.
2. Check the fiber-optic cable type match the SFP transceiver model.
¾
To connect to 1000Base-SX SFP transceiver, use the multi-mode fiber cable- with one side must be male
duplex LC connector type.
¾
To connect to 1000Base-LX SFP transceiver, use the single-mode fiber cable-with one side must be male
duplex LC connector type.
Connect the fiber cable
1. Attach the duplex LC connector on the network cable into the SFP transceiver.
2. Connect the other end of the cable to a device – switches with SFP installed, fiber NIC on a workstation or a Media
Converter..
13