Planet Technology FGSW-2620VM - Manual (Page 58)

FGSW-2620VM User’s Manual
Figure 4-5-1 802.1x Configuration - System Configuration interface
Radius Server — In this situation, need a Radius server in the network, the normal topologies as below
1. Select the “Radius Server” mode.
2. The RADIUS Server configuration table includes the following fields:
OObject Description
Disable or enable 802.1x Protocol. 802.1x Protocol
Set the Radius Server IP address. Radius Server IP
Set the UDP destination port for authentication requests to the specified Radius
Server.
Server Port
Set the UDP destination port for accounting requests to the specified Radius
Server.
Accounting Port
Set an encryption key for use during authentication sessions with the specified
radius server. This key must match the encryption key used on the Radius Server.
Shared Key
Set the identifier for the radius client. NAS, Identifier
Apply Button Press this button to save the value on the Switch.
3. Setup the RADIUS server and assign the client IP address to the Web-Smart switch. In this case, field in the
default IP Address of the Web-Smart switch with 192.168.0.100. And also make sure the shared secret key is as
same as the one you had set at the switch RADIUS server – 12345678 at this case.
58