Pitney Bowes W680 - Manual (Page 19)

Pitney Bowes W660/W680 Operator Guide 2-7
Setting Up the W660/W680 Printer • 2
1. Attach the Wire Frame to the Printer.
1. Hook the bottom edge of the wire frame under the tabs
in the frame slide.
2. Rotate the wire frame and insert the curved metal bar on
the bottom of the frame into the height adjustment slot.
See photos below.
Assembling the
W660/W680
(continued)
Tabs
Height
Adjustment
Slot
Lock
Knob
Lock
Lever
Wire
Frame
Bottom
Edge
Curved
metal Bar
3. Adjust the height of the wireframe so it's positioned at
about a 45 degree angle. Turn the lock knob on the side
of the slide clockwise to hold the wireframe in position.
You can adjust both the height and side-to-side position
of the wireframe to accommodate the size and type of
the material you're running. We talk about this in the
next chapter.