Pitney Bowes W680 - Manual (Page 36)

3-8 Pitney Bowes W660/W680 Operator Guide
3 • W660/W680 Basics
When you set the feed gap for a number 10 envelope, the width
of the envelope will fall completely under the inside and middle
H-Blocks, but only half way under the outer H-Block.
In this case, remove the sliding fence, then follow this procedure:
1. Slide the #10 envelope over until it is under both fingers
of the outermost H-Block.
2. Lower the outer H-Block so it contacts the material, then
lock the H-Block in place.
3. With all H-Blocks locked in position, slide the envelope
back to its original position.
Setup Example Using # 10 Envelopes:
Setting Up A
Job (continued)