Pitney Bowes W680 - Manual (Page 25)

Pitney Bowes W660/W680 Operator Guide 2-13
Setting Up the W660/W680 Printer • 2
6. Install the Ink Jet Cartridges (Color & Black).
The printer uses Ink Jet Cartridges for printing. You must install a
black only cartridge (W660), or a black and a color cartridge
(W680), before you can print. To begin:
1. With the printer on, press the On Line key until the
display reads OFF LINE.
2. Open the Transport Door of the printer.
3. Press the Cartridge+ key on the control panel to move
the carriage to the middle of the printer.
4. Remove the color (W680 only) or black cartridge (both
models) from its shipping container by peeling the top
cover off. Be careful not to touch the copper ribbon.
Installing and
Removing the
Ink Jet
Cartridges
WARNING! The ink in the cartridge may be
harmful if swallowed. Keep new and used car-
tridges out of reach of children. Discard empty
cartridges immediately.
5. Gently remove the tape covering the ink nozzles on the
print cartridge. Be careful not to touch the copper nozzles.
6. Gently insert the cartridge (color to the right, black to
the left) into the carriage at approximately a 20 degree
angle with copper strip to the bottom and in first. Press
down on the cartridge until it is seated.
Note: The print
cartridge photos in
this section are of
the W680 printer.
The W660 has only
one cartridge.