Pitney Bowes W680 - Manual (Page 38)

3-10 Pitney Bowes W660/W680 Operator Guide
3 • W660/W680 Basics
3. Set the Feed Angle Setting Up A
Job (continued)
The feed angle of the wireframe input stacker depends on the
type of material you're running:
•
Heavy material—adjust to a low angle
• Standard material—adjust to the center (45 degree angle)
• Light material—adjust to a high angle
To make the adjustment:
1. Loosen the lock knob on the wireframe slide.
2. Move the wireframe up or down as required.
3. Tighten the lock knob to secure the wireframe.
Lock Knob
Wire Frame