Pitney Bowes W680 - Manual (Page 44)

3-16 Pitney Bowes W660/W680 Operator Guide
3 • W660/W680 Basics
1. Make sure material is loaded properly. (Or you can use a
single test piece if you'd like to check your setup adjust-
ments.)
2. Turn the printer ON. The On/Off switch is located on the
interface panel at the rear of the machine. Wait for the
printer to finish its startup routine and for the "ON
LINE" screen to appear on the LCD.
3. Press the On Line button on the printer control panel
until the LCD display reads OFF LINE.
4. Press the "Test Env." button. A single envelope will feed
and a sample address should print.
5. Check the print quality. If it's not what you want, adjust
the media thickness lever (page 3-14) as required and run
another test piece by pressing the Test Env. button on the
interface panel at the rear of the machine.
9. Print a Test Piece Setting Up A
Job (continued)
When you're satisfied with the setup adjustments, you're ready to
run the job. The next chapter explains use of the printer with
your computer.
Test Env. On Line Display