Installing the rail kit – Powerware 9135 Two-in-One UPS 5000/6000 VA User Manual
Page 30
Advertising
INSTALLATION
EATON Powerware
®
9135 Two−in−One UPS (5000/6000 VA) User’s Guide
S 164201726 Rev 1
www.powerware.com
24
Installing the Rail Kit
C
A
U
T
I
O
N
S
DO NOT install the UPS or EBM in a hermetically−closed environment without any
exchange of air.
S
The UPS and EBM are heavy (see page 65): 1) Eaton strongly recommends to remove the
battery tray from the UPS before lifting. 2) A minimum of two people are required to lift
the cabinets into the rack.
NOTE The rails and the necessary mounting hardware are supplied by Eaton.
To install the rail kit:
1.
Adjust the UPS control panel orientation by slightly pulling out the
control panel and rotating it 90° counterclockwise (see Figure 4).
Figure 4. Adjusting the UPS Control Panel Orientation
Advertising