Connecting the power cables (eu models) – Powerware 9135 Two-in-One UPS 5000/6000 VA User Manual
Page 46
INSTALLATION
EATON Powerware
®
9135 Two−in−One UPS (5000/6000 VA) User’s Guide
S 164201726 Rev 1
www.powerware.com
40
Connecting the Power Cables (EU Models)
W
A
R
N
I
N
G
S
Only qualified service personnel (such as a licensed electrician) shall perform the
electrical connection. Risk of electrical shock.
S
Before carrying out any connection, check that the battery circuit breaker and upstream
protection device (utility input) are OFF (O).
S
Use included insulated ferrules with stranded wires.
1.
Remove the terminal block cover (two screws) with the supplied
screwdriver (see Figure 21).
Input Cable Opening
Output Cable Opening
Figure 21. Removing the Terminal Block (EU Models)
2.
Insert the input cable through the input cable opening (see
Figure 22).
3.
Connect the three wires to the input terminal block.
C
A
U
T
I
O
N
Always connect the ground/earthing wire first.
4.
Insert the output cable through the output cable opening.
5.
Connect the three wires to the output terminal block.