Powerware 9135 Two-in-One UPS 5000/6000 VA - Manual (Page 48)

INSTALLATION
EATON Powerware ® 9135 Two−in−One UPS (5000/6000 VA) User’s Guide S 164201726 Rev 1
www.powerware.com
42
Connecting the Power Cables (U Models)
W A R N I N G
S
Only qualified service personnel (such as a licensed electrician) shall perform the
electrical connection. Risk of electrical shock.
S
Before carrying out any connection, check that the battery circuit breaker and upstream
protection device (utility input) are OFF (O).
S
Use included insulated ferrules with stranded wires.
1. Remove the terminal block cover (two screws) with the supplied
screwdriver (see Figure 21).
BAT
T
. NO .
200 −25 0V~, 24A
RPO
RS− 232
CAUT IO N: DO N O T D IS CO NNECT BATTERY C ABLE UNDER L O AD BATT ERY CO NNECTO R 180VD dc
Input Cable
Output Cable
Opening
Figure 24. Removing the Terminal Block (U Models)
2. Connect the three wires to the input terminal block.
C A U T I O N
Always connect the ground/earthing wire first.
3. Insert the output cable through the output cable opening.
4. Connect the three wires to the output terminal block.