Paradyne T1 T1 Access Mux 926x - Manual (Page 90)

Setting Up
5-36 9161-A2-GH30-30 April 1998
Assigning Cross Connections
The system allows you to assign data paths between the various interfaces to
share the T1 network. Assuming that both the Network and DSX-1 interfaces are
enabled and that at least one voice port APM is installed, you can make the
following cross connections:
H
Assign DSX-1 time slots to the Network interface
H Assign Network 2 interface timeslots to the Network 1 interface
H
Assign voice ports to DSX-1 or Network interface timeslots
H
Assign Sync Data ports to DSX-1 or Network interface timeslots, or to
another Sync Data port
H Assign OCU-DP data ports to DSX-1 or Network interface timeslots
You can also clear cross-connection assignments.
NOTE:
Although it is not required, it is suggested that you progress through each
screen in order, from top to bottom.