Panasonic CX-D3000U - Manual (Page 39)

Electrical Connections
(continued)
E
N
G
L
I
S
H
35
CX-D3000U
44 44
PARKING BRAKE
Chasiss
Battery
Brake lamp
5 Clamp connector
Parking brake
switch
Side brake (parking brake)
connection lead
(Blue/yellow stripe)
Of the 2 cords emerging from the parking brake switch,
connect the player’s parking brake cord to the one that is
not connected to the vehicle’s chassis while the brake is
in the released state.
Cords connected to
the vehicle.
❐ Connecting side brake (parking brake) connection lead
Vehicle cord
Parking brake cord
Element
Cover
Push the end of the cord
in until it touches this part.
3
Close the cover until
it snaps shut. 1
Push the end of the side brake
cord into the hole on the clamp
connector.
Place the vehicle cord into the
groove in the clamp connector.
2
While making sure that the cords
do not slip out of the clamp
connector, press the element
down with a pair of pliers.
Caution:
≥ For safety, be sure to ask your nearest professional installer to do this connection.
The side brake (parking brake) switch position
varies with the car model.
For details on the exact location of the parking
brake switch in your car, contact your dealer.
Side brake (parking brake)
Foot brake
Connecting the Clamp Connector
5
≥ Attach the clamp connector to the vehicle cord at a suitable position.
≥ Note that if the cord being clamped onto is too thin (0.3 mm 2 or less), the connection may not be
adequate.