Panasonic KX-HGC200 - Manual (Page 19)

19
For assistance, please call: 1-800-272-7033
Installation
4 Click [Save] .
≥ After the “Success” screen appears, the Broadband Networking Gateway
restarts and you will connect to the administration initial screen.
5 Restart all the computers that are connected to the Broadband
Networking Gateway.
The KX-HGC200 has been successfully set up and is ready to
communicate with others. Refer to pages from 25 and set up each
computer that you want to add to a wireless network.
Setting up from a wireless computer
To set up the Broadband Networking Gateway from a wireless
computer, the wireless computer must have already configured the
KX-HGC200. For more details about how to configure the
KX-HGC200, refer to “
Required setup for each computer” on p. 11.
Below steps for configuration are performed on the Network Management
web screen of the wireless computer. All of the computers in the wireless
network can use this function and configure the Broadband Networking
Gateway.
1 Turn on the Broadband Networking Gateway.
“
About the network name
To communicate with others in a wireless group, the same
Network Name must be programmed into each computer. It is
impossible to communicate with a computer that has a different
Network Name. To join a wireless network, it is necessary to
enter the Network Name that is common to that particular
network. For security, specify a unique Network Name that
others do not guess, using more than 8 digits or characters, for
a wireless network.
Note:
To set up from a wireless computer, the KX-HGC200 must be set to
use the radio frequency channel 6 and the FEC (p. 62) must be
activated.