Panasonic KX-HGC200 - Manual (Page 70)

70
“ Troubleshooting
Problem
The Network management
web screen is not
displayed.
You cannot connect with
the computer.
You cannot connect with
the Broadband Networking
Gateway.
Remedy
≥ The KX-HGC200 device driver may
have not been installed successfully.
Make sure the driver is installed.
≥ The computer and/or the Broadband
Networking Gateway may have not
been configured properly. Check the
settings of the computer and/or the
Broadband Networking Gateway.
≥ The channel numbers of the
computers and/or the Broadband
Networking Gateway vary in the same
network. Check their channel
numbers.
≥ Even if the Network Names of the
computers and the Broadband
Networking Gateway are same, their
Network ID may vary in the same
network. Re-enter the Network Name
by using the Device Management
dialog box.
≥ The computer and/or the Broadband
Networking Gateway may be out of
radio waves, or the concrete wall etc.
may be disturbing the waves. Set the
computers closely.
≥ More than one computers are set to
the Master Node. Check the setting of
each computers.
≥ Check the setting of the IP address.
≥ The Network Manager may not be
installed. Make sure the “Network
Manager” icon is displayed on the
taskbar.
≥ The Network Manager recognizes a
different IP address from that of the
computer to which the KX-HGC200 is
attached. Check the Properties tab of
the Device management dialog box
(p. 59), then click
[Refresh] to update
the information.