Panasonic AW-HB505 - Manual (Page 17)

M E M O R Y
P R E S E T
2 1 3 4 5
6 7 8 9 1 0
-15-
OPERATION
1. Power
Set the power switches on the pan/tilt head AC adapter
and the multiport hub AC adapter to the ON position,
then set Power control Switch on the multi control panel
to the ON position.
2. Pan/tilt Limiter Setting for Pan/tilt Head
If there are obstacles around the pan/tilt heads, set the
limiters to limit the operating range (pan left and right
ends, tilt up and down ends) of the pan/tilt head.
Note: The switches on the pan/tilt head have been pre-
set before shipment from the factory on the
assumption that the pan/tilt head would be sus-
pended from the ceiling. If the pan/tilt head is
mounted on a board, for example, be sure to shift
the mounting direction switches on the pan/tilt
head. Unless this is done, pan/tilt directions will be
reversed and pan/head operation limiter data can-
not be properly stored in the memory. For details
on shifting these switches, refer to INSTALLATION
OF PAN/TILT HEAD at page 8 or the Operating
Instructions for Pan/tilt Head.
q Select a pan/tilt head with the CONTROL switch on the
multi hybrid control panel.
w Left Panning Limiter
Turn the pan/tilt head to the desired left panning limit
with PAN/TILT Lever of the multi hybrid control panel,
keep MEMORY Switch depressed, and simultaneously
press buttons [1] and [6] of PRESET Switch for 5 sec-
onds or more. When the desired limit has been set,
button [5] of PRESET Switch lights.
To reset the limit, keep the MEMORY switch
depressed, and simultaneously press buttons [1] and
[6] of PRESET Switch again for 5 seconds or more.
When the set limit is reset, button [10] of PRESET
Switch lights.
Up tilting limiter Preset position selection switch
Left panning
limiter
Preset
memory
switch Right panning
limiter
Lights on
completion
of resetting
Down titing
limitor
Lights on
completion
of setting