Panasonic AW-HB505 - Manual (Page 18)

-16-
e Right Panning Limiter
Turn the pan/tilt head to the desired right panning limit
with PAN/TILT Lever of the multi hybrid control panel,
keep MEMORY Switch depressed, and simultaneously
press buttons [4] and [9] of PRESET Switch for 5 sec-
onds or more. When the desired limit has been set,
button [5] of PRESET Switch lights.
To reset the limit, keep the MEMORY Switch
depressed, and simultaneously press buttons [4] and
[9] of PRESET Switch again for 5 seconds or more.
When the set limit is reset, button [10] of PRESET
Switch lights.
r Up Tilting Limiter
Turn the pan/tilt head to the desired up tilting limit with
PAN/TILT Lever of the multi hybrid control panel, keep
MEMORY Switch depressed, and simultaneously press
buttons [2] and [3] of PRESET Switch for 5 seconds or
more. When the desired limit has been set, button [5]
of PRESET Switch lights.
To reset the limit, keep the MEMORY switch
depressed, and simultaneously press buttons [2] and
[3] of PRESET Switch again for 5 seconds or more.
When the set limit is reset, button [10] of PRESET
Switch lights.
t Down Tilting Limiter
Turn the pan/tilt head to the desired down tilting limit
with PAN/TILT Lever of the multi hybrid control panel,
keep MEMORY Switch depressed, and simultaneously
press buttons [7] and [8] of PRESET Switch for 5 sec-
onds or more. When the desired limit has been set,
button [5] of PRESET Switch lights.
To reset the limit, keep the MEMORY switch
depressed, and simultaneously press buttons [7] and
[8] of PRESET Switch again for 5 seconds or more.
When the set limit is reset, button [10] of PRESET
Switch lights.
y Select a pan/tilt head with the CONTROL switch on the
multi hybrid control panel, and set the its operating
range limiters. Repeat the same process for each of
the other pan/tilt heads.
3. Cable Compensation Setting, Genlock and
Total Pedestal Adjustment
1) After selecting a camera with the CONTROL switch on
the multi hybrid control panel, set the CAM CONT
switch to the ON position.
Note: When the CAM CONT switch on the multi hybrid
control panel is set to the ON position, the switch
settings of the multi hybrid control panel are sent
to the camera to update its settings. Do not set
the CAM CONT switch to the ON position except
when changing the camera settings. If another
camera is selected with the CONTROL switch
while the CAM CONT switch is in the ON position,
the settings of the selected camera will be similarly
changed. Set the CAM CONT switch back to the
OFF position before changing one camera for
another with the CONTROL switch.