Panasonic KX-FT31BX - Manual (Page 17)

17
Setup
In
it
ia
l
P
re
p
a
ra
tio
n
Installing the recording paper
Note:
● Only use the included roll of paper or specified recording paper, or else the print quality may be affected
and/or excessive thermal head wear may occur.
● To order recording paper, see page 5.
● When the power cord is connected, everytime you close the cover a message will be printed. If the recording
paper is set to the wrong side, a message will not be printed. Install the paper correctly.
1
Open the cover by pressing the cover open
button and install the recording paper roll.
● If the paper is secured with glue or tape, cut
approximately 15 cm (6 inches) from the
beginning.
2 Pull the leading edge of the paper approximately
10 cm (4 inches) out of the unit.
● Make sure that the shiny side of the paper is
facing down and there is no slack.
3 Close the cover securely by pushing down on
both corners.
● When you close the cover, do not push the
flaps down or a paper jam will occur.
Cover open
button
10 cm
correct incorrect
4 Tear off the excess paper by pulling it towards
you.
Flaps