Printronix ANSI Printer - Manual (Page 39)

Resetting
39
Resetting
ASCII Code ESC c
Hex Code 1B 63
Dec Code 27 99
Expression CHR$(27);“c”;
Purpose Resets the printer’s configuration parameters. Depending on
which option was selected in the “Reset Cmd CFG Ld” menu,
the parameters are set to the factory default configuration,
power-up configuration, or the current configuration. If “Reset
Cmd CFG Ld” is disabled in the menu, the hardcoded
parameters shown in Table 7 are set.
Discussion The following attributes, which are not part of the configuration,
are also reset:
Character rotation is reset to no rotation.
Character expansions are set to 1x1.
Subscript and superscript are turned off.
Underscoring is turned off.
Plot mode is terminated.
The horizontal and vertical tabulation tables are cleared.
The default EVFU table is loaded.
Bar code parameters are set to default values.
Graphic line density is set to 60 horizontal DPI x 72 vertical DPI.
The current line is set as the top-of-form (TOF) position.
Table 7. Hardcoded Reset Values
Parameter Setting
Font style Data processing
Character size 1 x vertical; 1 x horizontal
Character pitch 10 CPI
Country selection Latin 1 8859-1
Line spacing 6 LPI
Partial Line up Reset
Partial Line down Reset
Bold print Disabled
Underline mode Disabled
Expanded mode Disabled
Proportional mode Reset
Horizontal tab table Empty
Left margin None - column 0
Right margin None - Maximum
Page size 7920 decipoints/ 66 lines/ 11 inches
Top margin None
Bottom margin None
Forms position Top-of-form = current position
Vertical tab table Empty
Vertical format unit Default
Graphics density 60 Horizontal DPI, 72 Vertical DPI
VFU load in progress Exit (nothing saved)
Bar code mode Disabled
Dot graphics Disabled