Panasonic DMC-TZ1 - Manual (Page 105)

Others
105
VQT0V40
[PICTURE IS DISPLAYED FOR 4:3 TV]/
[PICTURE IS DISPLAYED FOR 16:9 TV]
• The AV cable is connected to the camera.
Press [MENU/SET] if you want to delete
this message at once.
• Select [TV ASPECT] in the [SETUP]
menu to change the TV aspect. (P23)
• This message also appears when the
USB connection cable is connected to the
camera only.
In this case, connect the other end of the
USB connection cable to a PC or a printer.
(P92, 95)
Troubleshooting
If you return the menu settings to the initial
settings at the time of purchase, the
condition may improve.
Select [RESET] in the [SETUP] menu.
(P23)
∫ Battery and power source
1: The camera cannot be operated even
when it is turned on.
• Is the battery inserted correctly?
– Check the direction of the battery.
(P14)
• Is the battery sufficiently charged?
– Use a battery that has been
sufficiently charged.
2: The LCD monitor turns off while the
camera is turned on.
• Is power save mode (P21) or economy
mode (P22) activated?
– Press the shutter button halfway to
cancel these modes.
• Is the battery exhausted?
– Charge the battery or replace it with a
battery which has enough capacity.
3: The camera turns off immediately
after it is turned on.
• Is the battery charge insufficient to
operate the camera?
– Use a battery that has been
sufficiently charged.
– If you leave the camera on, the
batteries will be exhausted. Turn the
camera off frequently by using power
save mode (P21), economy mode
(P22), etc.
VQT0V40ENG.book 105 ページ ２００６年２月２７日 月曜日 午後１時１９分