Philips M5066A - Manual (Page 3)

P
h
ilip
s M
e
di
ca
l Sy
st
e
m
s
The HeartStart Defibrillator M5066A
Pads Cartridge Handle.
Pull the handle to turn on the
HeartStart and remove the
cartridge’s hard cover.
Ready Light. This green light
tells you the readiness of the
HeartStart.
Blinking: standby mode
(ready for use)
Solid: in use
Off: needs attention
(HeartStart
“chirps” and
i-button flashes)
On/Off Button. Press this
green button to turn on the
HeartStart. To turn off the
HeartStart, press the green button
again and hold it down for one (1)
second.
Information Button. This
blue “i-button” flashes when it
has information you can access by
pressing it. It also flashes at the
beginning of a patient care pause
when CPR coaching is enabled.
Caution Light. This triangular
light flashes during rhythm
analysis and is on when a shock is
advised, as a reminder that no one
should be touching the patient.
Shock Button. When
instructed by the HeartStart to
deliver a shock, press this flashing
orange button .
Infrared (IR)
Communications Port. This
special lens, or “eye,” is used to
transfer HeartStart data directly to
or from a computer.
Speaker. When the device is
being used, its voice instructions
come from this speaker.
Beeper. The HeartStart
“chirps” through this beeper to
alert you when it needs attention.
SMART Pads Cartridge. This
disposable cartridge contains self-
adhesive pads with attached cable.
Shown with adult pads cartridge.
SMART Pads Cartridge
Latch. Slide the latch to the right
to release the pads cartridge for
replacement.
Battery. The non-
rechargeable battery is inserted in
a recess on the back of the
HeartStart.
A
B
C
D
E
F
G
H
I
J
K
L
top
top
C
B
D
E
G
F
H
A
front view
I
B
A
back view
K
L
K
L