Panasonic TX-47P950A - Manual (Page 14)

14
Convergence Adjustment
Convergence Adjustment mode
Prior to adjustment, tune the broadcast signal to the video input signal
and operate the set for more than 60 minutes. If the location or direction
of the set is changed or moved, the display may be out of alignment. If
necessary, carry out the following procedures once with PAL signal and
again with the NTSC signal.
Vertical centre marker
Horizontal centre marker
1 MENU
Press to display the MAIN MENU,and then to the SETUP menu.
2
3
Press to select the “CONVERGENCE”.
Press to access to the “CONVERGENCE” menu.
Press to select the “CONVERGENCE 1” or the “CONVERGENCE 2”.
Press to access to the function.
SETUP MENU
PICTURE SHIFT
TUNING MENU
OWNER ID
CONVERGENCE
3D-COMB ON
ON
ACCESS
CONVERGENCE 1
CONVERGENCE 2
ACCESS
Example:
CONVERGENCE 1
is selected.
Convergence 1 Adjustment for RED, BLUE and GREEN
RED
BLUE
GREEN
Press to align the horizontal red line with the horizontal blue line.
(Becomes a white line)
Press to align the vertical red line with the vertical blue line.
(Becomes a white line)
Press “N” button to adjust the blue mode.
(Stores RED)
Press to align the horizontal blue line with the horizontal yellow line.
(Becomes a white line)
Press to align the vertical blue line with the vertical yellow line.
(Becomes a white line)
Press “N” button to adjust the green mode.
(Stores BLUE)
Only when you cannot adjust with RED and BLUE proceed to the following GREEN adjustment.
Press to align the horizontal green line with the vertical centre maker.
Press to align the vertical green line with the horizontal centre maker.
Press “N” button to adjust the red mode. (Stores GREEN)
Repeat above adjustment for each position.
TV/AV
Press at any time to return to the normal viewing.
CONVERGENCE
RED
EXIT
ADJUST
ADJUST
N- BLUE
CONVERGENCE
BLUE
ADJUST
ADJUST
EXIT
N- GREEN
CONVERGENCE
GREEN
ADJUST
ADJUST
EXIT
N- RED
Vertical centre marker
Horizontal centre marker