Panasonic TX-47P950A - Manual (Page 18)

18
Tuning Channels
Automatic Tune
This TV uses automatic tuning to determine whether or not the TV can receive a broadcast signal which is being sent, and automatically
prepares so that the channel selection can respond to direct select modes. Before Automatic Tune, Regional System must already
be set (Refer to pages 16).
1 AUTO TUNE
Press to select the “AUTO TUNE”.
Press to access to the “AUTO TUNE”.
Search Start.
When a station is found.
The best tuning position is automatically memorized.
2 SOUND SYS After all stations are tuned, the on-screen display will automatically change from “AUTO TUNE”
to “SOUND SYS” Position.
Press to improve the Sound quality, if the Sound is not clear or
no sound is produced on a programme Number Position.
4.5MHz
6.5MHz
5.5MHz
6.0MHz
Press to store the Sound System.
Press to exit from the Tuning Menu.
This returns the set to the normal viewing condition.
Note:
When the sound volume is too small to confirm, turn it up by using the sound volume button on the remote control.
3
Under the normal viewing condition press to enter each programme Number.
Confirm the tuning condition.
If necessary, repeat step 2 for each Programme Number.
TV/AV
OK
AUTO SETUP IN PROGRESS
SEARCHING : PLEASE WAIT
RETURN
TO EXIT
SYS SELECT
TUNING MENU
AUTO TUNE
MANUAL TUNE
FINE TUNE
SKIP
SOUND SYS
COLOUR SYS
AUTO
OFF
ACCESS
5.5 MHz
AUSTRALIA
SYS SELECT
TUNING MENU
AUTO TUNE
MANUAL TUNE
FINE TUNE
SKIP
SOUND SYS
COLOUR SYS AUTO
OFF
5.5 MHz
AUSTRALIA