Pelco DX8100 - Manual (Page 21)

C2629M-A (6/07) 21
Hardware Setup
BASIC CONNECTIONS
IN1 IN2 IN3 IN4 IN5 IN6 IN7 IN8 IN9 IN10 IN11 IN12 IN13 IN14 IN15 IN16
OUT16 OUT15 OUT14 OUT13 OUT12 OUT11 OUT10 OUT9 OUT8 OUT7 OUT6 OUT5 OUT4 OUT3 OUT2 OUT1
ALARM INPUTS RELAY OUTPUTS
1 2 2 4 5 6 7 8 GND
9 10 11 12 13 14 15 16 1 2 2 4 5 6 7 8 GND
9 10 11 12 13 14 15 16
VGA
KEYBOARD MOUSE
POWER
CONNECTION
SPECTRA
CAMERA
Figure 9. Basic Connections
Make the following connections on the rear of the recorder. Refer to Figure 9.
ì
Connect the appropriate power cord to the back of the unit and to a power source.
The DX8100 contains an autoranging power supply. It is recommended that the recorder be connected to an uninterruptible power supply
(UPS) capable of supplying 2 A for 120 VAC power systems or 1 A for 230 VAC power systems.
î
Connect the mouse to the top PS/2 input.
ï
Connect the keyboard to the bottom PS/2 input.
ñ
Connect a VGA monitor (not supplied).
ó
Connect the cameras to the BNC connectors. Refer to Table B for video coaxial cable requirements. Connect power to the cameras.
Table B. Video Coaxial Cable Requirements
Cable Type* Maximum Distance
RG59/U 750 ft (229 m)
RG6/U 1,000 ft (305 m)
RG11/U 1,500 ft (457 m)
*Minimum cable requirements:
75 ohms impedance
All-copper center conductor
All-copper braided shield with 95% braid coverage
When connecting cameras using these types of cable, use a
patch panel. Do not connect these cables directly to the
DX8100.