Pride Mobility Dynamic Controller INFMANU3676 - Manual (Page 14)

14 Basic Operation Instructions
Dynamic Controller www.pridemobility.com
Keypad
The keypad is located directly in front of the joystick. It contains keys that
you will use to control your power chair. See figure 2.
On/Off Key
The on/off key turns the system on and off.
WARNING! Unless faced with an emergency situation, do
not use the on/off key to stop the chair. This will cause the
power chair to stop abruptly.
WARNING! Always turn the power off when you are
stationary to prevent unexpected movement.
NOTE: If the joystick is not in the neutral (center) position when you turn
on the power, you may cause a fault in the system. See “Out Of Neutral At
Power Up (OONAPU).”
Horn Key
The horn key activates a warning horn.
Battery Condition Meter
The battery condition meter consists of eight lights arranged in an arc over
the on/off key. As the battery voltage drops, the number of lights reduces
from right to left. When the battery capacity drops to 10% or below, the left
red LED will flash.
„ Left Red LED Flashing: The battery charge is low; charge the batteries
as soon as possible.
„ Right-to-Left Ripple of LEDs: The controller is in lock mode; unlock
the controller.
„ Left-to-Right Ripple of LEDs Alternating with Steady Display: The
controller is in programming, inhibit, or charging mode. When the
joystick is moved, the speed gauge will also flash.
Speed Keys
There are two keys that control the speed. Press the speed increase key to
increase the speed. Press the speed decrease key to decrease the speed. The
speed setting is displayed on the speed setting indicator. If your power chair
was programmed with a drive profile, contact your authorized Pride Pro-
vider for more information.