Pride Mobility Dynamic Controller INFMANU3676 - Manual (Page 16)

16 Basic Operation Instructions
Dynamic Controller www.pridemobility.com
WARNING! Only chargers with Neutrik NC3MX plugs should
be connected to the off-board charger/programming
socket. See your authorized Pride Provider for more
information.
NOTE: The socket may also be used for reprogramming the Dynamic
controller. Contact your authorized Pride Provider for more information.
LOCK MODE
The Dynamic controller is equipped with a feature that enables you to “lock-
out” unauthorized users.
To lock the Dynamic controller:
1. While the power is on, press and hold the on/off key for 4 seconds. The
display will turn off immediately. After 4 seconds, all LEDs will flash
briefly and the horn will sound a short beep.
2. The Dynamic controller is now locked.
Light Key (For Optional Equipment)
The light key turns the headlights/taillights on and off independent of other
indicators.
Hazard Key (For Optional Equipment)
The hazard key activates both turn indicators at the same time. You can only
cancel this by pressing the hazard key again.
CONTROLLER CONNECTOR
This connects the Dynamic controller to the power module located on the
power base.
OFF-BOARD CHARGER/PROGRAMMING SOCKET
You may use an off-board charger
to charge the power chair batteries
through the 3-pin socket located
on the front of the Dynamic con-
troller. See figure 7. If you use an
off-board charger, the charger
current should not exceed 8 amps.
Contact your authorized Pride
Provider for more information.
Figure 7. 3-pin Off-board Charger
Socket