Pride Mobility Dynamic Controller INFMANU3676 - Manual (Page 18)

18 Basic Operation Instructions
Dynamic Controller www.pridemobility.com
SLEEP MODE (IF ENABLED)
The power chair controller features a sleep mode. Sleep mode is a built-in
circuit that will automatically shut off the main power if the joystick is not
moved in any direction for a period of time. This time factor is programmed
into the controller. To restore power and continue, push any key on the key-
pad.
OUT OF NEUTRAL AT POWER UP (OONAPU)
Your power chair joystick is equipped with Out Of Neutral At Power Up
(OONAPU). If you power up the system and the joystick is not in the neutral
position, all of the lights in the speed setting indicator will flash rapidly for
as long as the joystick is out of the neutral position. Allow the joystick to
return to the neutral position and the fault will clear.
ERROR CODES
The service indicator will flash error codes when the Dynamic controller
detects an abnormal condition in the electrical system. The service indicator
will flash a number of times quickly, then pause, then flash again. The ser-
vice indicator will continue to flash the error codes until the problem is
fixed. The following table identifies the individual error codes. If any of
these error codes persist or if you experience any other problem with your
power chair, contact your authorized Pride Provider.
NOTE: When the service indicator flashes an error, the battery condition
meter LEDs will also flash an inhibit. See “Battery Condition Meter.”