Pride Mobility Dynamic Controller INFMANU3676 - Manual (Page 17)

Basic Operation Instructions 17
www.pridemobility.com Dynamic Controller
To unlock the Dynamic controller:
1. While the Dynamic controller is locked, press the on/off key to turn on
the controller. All LEDs will flash briefly. The LEDs will then slowly
ripple from right to left.
2. Press the horn key twice before the LED ripple has completed,
approximately 10 seconds. The controller is now unlocked.
NOTE: If you do not press the horn key twice before the countdown is
complete, the system will beep and the Dynamic controller will turn itself
off. The unlock sequence must be completed successfully before the
Dynamic controller will operate again.
ACTUATOR ADJUSTMENT
The Dynamic controller can control two actuators using the mode key and
the joystick. The active actuator is indicated by an illuminated actuator
LED. See figure 4, 5, or 6.
To select and adjust an actuator:
Figure 8. Actuator
Indicators (None, Actuator
1, and Actuator 2 Shown)
1. Press the on/off key to power on the
controller.
2. Press the actuator select key once to select
Actuator Adjustment Mode. Actuator 1
will be active as noted by the amber “1”
indicator.
3. Push the joystick to the right or press the
actuator select key again to cycle through
the available actuators. The actuator
indicators will display which actuator is
activated. See figure 8.
4. When the desired actuator is selected,
give a forward command to the joystick to
raise the actuator or give a reverse
command to the joystick to lower the
actuator.
5. Press the actuator select key again to
return to the Drive Mode.