Philips FWM387/12 - Manual (Page 19)

18 EN
8 Record
Note
To record, use only “Normal” (IEC type I) tapes on •
which the write-protect notches (tabs) are not broken.
When you play or record a tape, the sound source
•
cannot be changed.
Auto record from CD to
tape
1
Select the disc source.
2
Load a disc.
3
Pull at OPEN on the front panel to
open the tape button cover.
4
Press to open the tape door.
5
Load the tape with the open side
downward and the full spool to the left.
6
Press to start recording.
Disc play starts automatically from the »
beginning of the disc.
To pause recording, press • . To
resume recording, press this button
again.
To stop recording, press
• .
Record a section of a disc to tape
1
During disc play, press and hold / to
search, then release the button.
To select a track, press • / .
2
Press to pause disc play.
3
Load a tape.
4
Press to start recording.
Disc play resumes automatically. »
To pause recording, press • . To
resume, press this button again.
To stop recording, press
• .
Record from radio to tape
1
Tune to the desired radio station. (see
‘Tune to a radio station’ on page 17 )
2
Pull at OPEN on the front panel to
open the tape button cover.
3
Press to open the tape door.
4
Load a tape.
5
Press to start recording.
To pause recording, press • . To
resume, press this button again.
To stop recording, press
• .
Tip
The best recording level is set automatically. Change of •
volume and sound effect does not affect recording.
The quality of recorded sound can differ depending on
•
the source and the tape used.
FWM387_DFU_ENG_12.indd 章节1:18 FWM387_DFU_ENG_12.indd 章节1:18 1/16/2009 11:07:04 AM 1/16/2009 11:07:04 AM