Philips FWM387/12 - Manual (Page 23)

22 EN
11 Troubleshooting
Warning
Never remove the casing of this apparatus. •
To keep the warranty valid, never try to repair
the system yourself.
If you encounter problems when using this
apparatus, check the following points before
requesting service. If the problem remains
unsolved, go to the Philips web site (www.
philips.com/welcome). When you contact
Philips, ensure that the apparatus is nearby
and the model number and serial number are
available .
No power
Ensure that the AC power plug of the •
unit is connected properly.
Ensure that there is power at the AC
•
outlet.
To save power, the unit switches to
•
standby automatically 15 minutes after
a play reaches the end and no control is
operated.
No sound or poor sound
Adjust the volume. •
Check that the speakers are connected •
correctly.
Check if the stripped speaker wires are
•
clamped.
Left and right sound outputs reversed
Check the speaker connections and •
location.
No response from the unit
Disconnect and reconnect the AC power •
plug, then turn on the unit again.
Remote control does not work
Before you press any function button, •
fi rst select the correct source with the
remote control instead of the main unit.
Reduce the distance between the remote
•
control and the unit.
Insert the batteries with their polarities •
(+/– signs) aligned as indicated.
Replace the batteries.
•
Aim the remote control directly at the •
sensor on the front of the main unit.
No disc detected
Insert a disc. •
Check if the disc is inserted upside down. •
Wait until the moisture condensation at •
the lens has cleared.
Replace or clean the disc.
•
Use a fi nalized CD or correct format disc. •
Cannot display some fi les in USB device
The number of folders or fi les in the USB •
device has exceeded a certain limit. This
phenomenon is not a malfunction.
The formats of these fi les are not
•
supported.
USB device not supported
The USB device is incompatible with the •
unit. Try another one.
Poor radio reception
Increase the distance between the unit •
and your TV or VCR.
If the signal is too weak, adjust the
•
antenna or connect an external antenna
for better reception.
Clock/timer setting erased
Power has been interrupted or the power •
cord has been disconnected.
Reset the clock/timer.
•
Timer does not work
Set the clock correctly. •
Switch on the timer. •
FWM387_DFU_ENG_12.indd 章节1:22 FWM387_DFU_ENG_12.indd 章节1:22 1/16/2009 11:07:08 AM 1/16/2009 11:07:08 AM