Panasonic DMR-E30 - Manual (Page 67)

67
Glossary (continued)
Q Link (For Continental Europe)
This function works only if the unit is connected via a fully-wired 21-pin Scart cable to a TV featuring the Q Link or similar function.
Q Link offers the following functions:
1) Download from the TV*
When you connect the unit to a TV, the station list data is automatically copied from the TV to the unit, and the TV stations are assigned to
the programme positions on the unit in the same order as on the TV.
2) Direct TV Recording
By simply pressing [DIRECT TV REC] (17), you can at once record the same programme that you are watching on the TV.
3) TV/DVD Auto Power On*
Even if the TV and the unit are off (standby mode), pressing [ 1] (21), [ShowView] ([G-Code]) (2) or [PROG/CHECK] (13) automatically
turns on both the TV and the unit.
4) DVD Auto Power Off*
When you turn the TV off, the unit is turned off as well. However, this function works in the stop mode.
This function does not work during the following operations: Preset Download, Auto Setup, Auto Clock Setting and Manual Tuning.
5) On-Screen Messages*
When you are watching a TV programme, the following unit messages appear on the TV screen to inform you of the unit’s condition:
≥Depending on the type of TV used, the above messages may not appear correctly.
* The operations marked with asterisk are only available if the unit is connected to a TV featuring the Q Link or the DATA LOGIC function.
Note
If “Power Save” is set to “ON”, the Q Link functions do not work when the unit is switched off (standby mode).
Message Message appears when:
This programme has already
started
A timer recording has just started.
Set DVD to timer standby mode The unit is not in the timer standby mode 10 minutes before the programmed recording start time
of a timer recording (message appears every minute during these 10 minutes).
DVD is in timer standby mode [DVD, Í] (1) or [<, OPEN/CLOSE] (39) was pressed, although the unit is in the timer standby
mode.
DVD is in timer recording mode [DVD, Í] (1), [∫] (7), [¥ REC] (16), [;] (8) or [ShowView] ([G-Code]) (2) was pressed while
the unit is in the timer recording mode.