Panasonic SV-P20U - Manual (Page 46)

46
Always Keep the Terminals of the
Battery Clean.
Prevent the terminals from getting
clogged with dirt, dust, or other
substances.
If you drop the Battery accidentally,
check to see if the Battery body and
terminals are deformed.
Attaching damaged Battery to the
printer may damage the printer.
Cautions for Storage
≥Extremely high temperatures or low
temperatures will shorten the life of the
Battery.
≥Do not allow the Battery terminals to
come in contact with metal objects (such
as necklaces, hairpins, etc.). This can
result in a short circuit or heat generation
and, if you touch the Battery in this
condition, you may be badly burned.
ª State of Power Lamp While
Charging
The [ON] Lamp flashes while charging.
(Flashes approx. every 2 seconds when
charging is normal.)
When the Power Lamps flashes more
quickly or slowly (or turns off), some
abnormality may have occurred.
The flashing speed suggests the following
states.
Flashing approx. every 0.5 seconds:
≥This printer, battery or AC adaptor may
be defective. Contact your nearest
Panasonic dealer.
Flashing approx. every 6 seconds:
≥The ambient temperature or that of the
battery itself is too high or too low.
Charging proceeds, but will take a longer
time.
Turning off:
Charging is completed.
If the [ON] Lamp turns off when charging is
not completed, the following reasons are
probable.
≥The ambient temperature or that of the
battery itself is too high or too low. Wait
until the proper temperature is reached
and charge the Battery again.
≥The AC Adaptor is probably defective.
Contact your nearest Panasonic dealer.
If the battery runs out quickly:
≥If a fully charged battery runs out quickly,
the printer may be defective. Contact
your nearest Panasonic dealer.
≥A defective battery may run out quickly.
Battery remaining capacity indication:
Along with the battery remaining capacity
being decreased, the indication will
change as follows:
r
l
s
l
t
l
u
l
v
≥When you use the printer, it is
recommended to use it with a fully
charged battery.
≥If the battery is not charged sufficiently,
the number of sheets that can be printed
may become extremely limited.
≥If you start printing when the u (red)
indication appears, the printer may stop
while printing. When the
u (red)
indication appears, recharge the battery
or use the AC adaptor for printing .
ª Notes on Memory Cards
≥Only an SD Memory Card or
MultiMediaCard can be used for this
printer.
≥Do not touch the terminals on the back of
the Card with your fingers. Do not allow
dirt, dust or water to contact the
terminals.
≥When the [CARD ACCESS] sign is
displayed in red, do not remove the
Card, turn off the power, or subject it to
vibration or impact.