Panasonic KXTG4321 - Manual (Page 26)

Programming
26 For assistance, please visit http://www.panasonic.com/help
L When the handset is in use, the alarm
will not sound until the handset is in
standby mode.
L If you select “Once”, the setting
changes to “Off” after the alarm
sounds.
L
When the ringer volume for outside
calls is set to off (page 23), the alarm
sound is heard at a low level.
Customer support
The handset can display the Internet
address where you can download the
operating instructions or get further
information for this product by using your
computer.
1
{ MENU} i {#}{6}{8}{0}
2
{ OFF}
Registering a unit
Operating additional
handsets
Additional handsets
Up to 4 handsets can be registered to
the base unit.
Important:
L
See page 5 for information on the
available model.
Registering a handset to a
base unit
The supplied handset and base unit are
pre-registered. If for some reason the
handset is not registered to the base
unit, register the handset.
1 Handset:
{
MENU} i {#}{1}{3}{0}
2 Base unit:
Press and hold {LOCATOR} for 4
seconds until the registration tone
sounds.
L
If all registered handsets start
ringing, press the same button to
stop. Then repeat this step.
L The next step should be
completed within 90 seconds.
3 Handset:
Press {OK}, then wait until a long
beep sounds.
4
{ OFF}
Note:
L
While registering, “Base
registering” is displayed on all
registered handsets.
L When you purchase an additional
handset, refer to the additional
handset’s installation manual for
registration.
Deregistering a handset
A handset can cancel its own
registration (or the registration of
another handset) that is stored in the
base unit. This allows the handset to end
its wireless connection with the system.
1
{
MENU} i {#}{1}{3}{1}
2
{ 3}{3}{5} i {OK}
3 Select the handset you want to
cancel by pressing the desired
handset number.
TG43xx_OI.book Page 26 Tuesday, December 11, 2007 2:04 PM