Panasonic BB-HCM331 - Manual (Page 22)

Installation/Troubleshooting
22
5. When using a router supporting UPnP TM , check [Enable]. When using a router
not supporting UPnP TM , check [Disable]. Then click [Next].
• Check if your router supports UPnP TM referring to the router's manual.
• If you select [Disable], skip to step 9.
6. To register with the "Viewnetcam.com FREE DDNS service", check [Register
with Viewnetcam.com] and click [Next].
Viewnetcam.com FREE DDNS service
See page 24 for Viewnetcam.com information. For detailed information,
access at http://www.viewnetcam.com.
• If you have multiple cameras, you can only register one camera for the
Viewnetcam.com service.
• If you select [Disable], skip to step 9.
7. The Enter Network Password window is displayed, and enter the user name
and password that were set, and click [OK].
8. After a while, the "Viewnetcam.com FREE DDNS service" website is
displayed. Follow the displayed instructions for registration.
• If the message "Failed to configure the router's Port Forwarding by UPnP"
is displayed, your router may not support UPnP
TM or UPnP TM is not
enabled. Enable your router's UPnP TM or set Port Forwarding manually
following the router's manual and try Automatic Setup again. For more
information about setting up a router, refer to the Panasonic Network
Camera support website at http://panasonic.co.jp/pcc/products/en/
netwkcam/.
• If the message "Failed to register with Viewnetcam.com." is displayed,
confirm that the router is connected to the Internet.