Panasonic SC-HT995W - Manual (Page 40)

RQ
T
8
7
6
6
40
T
roub
lesh
ootin
g gui
de
Troubleshooting guide
Before requesting service, make the following checks. If you are in doubt about some of the check points, or if the solutions indicated in the table do not
solve the problem, consult your dealer for instructions.
Power Page
Unresponsive or inoperable function
Specific operation undesirable or unexpected
Subtitle
No power. ≥ Insert the AC mains lead securely. 14
The unit is automatically switched
to standby mode. ≥ The Sleep timer was working and had reached the set time limit. 36
No response when any buttons
are pressed. ≥ This unit cannot play discs other than the ones listed in these operating instructions.
≥ The unit may not be operating properly due to lightning, static electricity or some other external
factor. Turn the unit off and then back on. Alternatively, turn the unit off, disconnect the AC mains
lead, and then reconnect it.
≥ Condensation has formed. Wait 1 to 2 hours for it to evaporate.
17
—
—
No response when remote control
buttons are pressed. ≥ Check that the batteries are installed correctly.
≥ The batteries are depleted. Replace them with new ones.
≥ Aim the remote control at the remote control signal sensor and operate. 15
15
16
No picture or sound. ≥ Check the video or speaker connection.
≥ Check the power or input setting of the connected equipment and the main unit.
≥ Check that the disc has something recorded on it.
6, 7,
11,
13, 14
—
—
You have forgotten your ratings
password.
Reset all the settings to Factory
Preset. ≥ While stopped and “DVD/CD” is the source, press and hold [∫] (Stop) on the main unit and [S10]
on the remote control until “Initialized” (or “Initialised”) disappears from the television. Turn the unit
off and on again.
All settings will return to the default values.
—
The HDAVI Control function does
not respond. ≥ Depending on the condition of the home theater system or the connected equipment, it may be
necessary to repeat the same operation so that the function can work correctly.
39
It takes time before play starts. ≥ Play may take time to begin when an MP3 track has still picture data. Even after the track starts, the
correct play time will not be displayed. This is normal. [MP3]
≥ This is normal on DivX video. [DivX]
—
—
Folders on a data CD are not
displayed correctly.
[WMA] [MP3] [JPEG] [MPEG4] [DivX] ≥ Folders deeper than the eighth layer are displayed as the eighth layer. —
A menu screen appears during
skip or search.
[VCD]
≥ This is normal for Video CDs. —
Playback control menu does not
appear.
[VCD] with playback control
≥ Press [∫ STOP] twice and then press [1 PLAY]. —
Program and Random play do not
work.
[DVD-V]
≥ These functions do not work with some DVD-Videos. —
Selecting audio soundtrack “2”
does not change the audio.
[DVD-A]
≥ Even if a second soundtrack is not recorded, two numbers are normally shown. —
Play does not start. ≥ This unit may not play WMA and MPEG4 that contains still picture data.
≥ If playing DivX VOD content, refer to the homepage where you purchased the DivX VOD content.
(Example: www.divx.com/vod) [DivX]
≥ If a disc contains CD-DA and other formats, proper playback may not be possible.
—
—
—
Play restarts from the beginning
when the soundtrack is changed.
[DVD-A] ≥ This is normal for DVD-Audio. —
Subtitle position is wrong. ≥ Adjust the position. (“Subtitle Position” in Display Menu) 27
No subtitles. ≥ Display the subtitles. (“Subtitle” in Main menu)
≥ Subtitles may not be displayed depending on the disc. [DivX] 24
—
HT995 & HT995W.book Page 40 Monday, April 24, 2006 6:08 AM