Panasonic SC-HT995W - Manual (Page 8)

R
Q
T
8766
8
Simple
Se
tu
p
∫ Attaching to a wall
You can attach all of the speakers (except subwoofer) to a wall.
≥ The wall or pillar on which the speakers are to be attached
should be capable of supporting over 15 kg ( [HT995W] 10 kg) per
screw. Consult a qualified building contractor when attaching the
speakers to a wall. Improper attachment may result in damage to
the wall and speakers.
≥ When mounting the front speakers or surround speakers to a
wall, we recommend using a string (not included) to prevent it
from falling.
1 [HT995W] Attach the cover plate to the front speaker or surround
speaker.
2 Drive a screw (not included) into the wall.
3 Fit the speaker securely onto the screw(s) with the hole(s).
Reattaching the speaker cable to the stand
[HT995]
1 Remove the two screws from the stand, and remove the metal cover.
2 Pull the cable out about 40 cm from the hole in the metal cover, and
insert the plastic cover.
3 Insert the metal cover
so it does not disturb
the cable and close
tightly with the two screws.
[HT995W]
1 Remove the eight screws
from the stand, and remove
the speaker net.
2 Position the cable.
3 Attach the speaker net with the screws.
∫ Fitting speaker stands
(not included)
(For center speaker)
Ensure the stands meet these conditions before purchasing them.
Note the diameter and length of the screws and the distance
between screws as shown in the diagram.
≥ The stands must be able to support over 10 kg.
≥ The stands must be stable even if the speakers are in a high position.
Speaker installation options
Preparation for front and surround speakers
[HT995]
1
Pull down the longer
part of the cable to
release the cable from
the groove inside the
stand, and then pull the speaker cable out from the stand.
2 Feed the cable into the bottom of the
speaker and through the slot at the rear.
3 Connect the cable ( ➜ page 6).
[HT995W]
1 Remove the speaker cable from the stand.
2 Connect the cable ( ➜ page 7).
[HT995W] 4 Cover plates [HT995W] 4 Screws
Release the cable
from the groove.
Screw
Tighten securely.
Cover plate
‰7.5 to 9.5 mm
5.0 to 7.0 mm Wall or pillar
‰4.0 mm
Front and surround speaker [HT995] Center speaker [HT995]
190 mm
255 mm
320 mm
106 mm
200 mm
Center speaker [HT995W]
340 mm
Front and surround speaker [HT995W]
In this position, the
speaker will likely
fall if moved to the
left or right. Move the speaker
so that the screw is
in this position.
e.g.
Screw
Metal cover
Screw
Plastic cover
Approx. 40 cm
Screw
Press the cable into
the groove.
Approx.
15 cm Cable
Speaker stand
(not included)
Plate thickness plus
7 mm to 10 mm
e.g. Center speaker [HT995]
5 mm, pitch 0.8 mm
Metal screw holes
For attaching to
speaker stands
60 mm
As
sem
b
ling
the
fr
ont
and
surr
ound
spe
ake
rs
8766En_p06-17.fm Page 8 Monday, April 24, 2006 6:47 AM