Philips VRZ250AT - Manual (Page 32)

1
Make the connections shown above.
32 Rerecording (Tape Duplication)
3
VCR 2 will record your tape. Insert a blank tape in VCR 2. The
VCR must be in VCR position. (The VCR/TV light will appear on the
display panel. If it does not, press the VCR/TV button once.)
4
Turn on the TV and set it to channel 03 or 04, whichever
channel the CH3/CH4 switch on VCR 2 is set to.
5
Point the remote control at VCR 2. Press Number buttons
0, 0 to select Line Input. A/V IN will appear on-screen.
6
Use the SPEED button to select SP, LP, or SLP at VCR 2.
7
Press the PLAY button on VCR 1 and the REC(ord)/OTR
button on VCR 2 at the same time.
To stop recording, press the STOP/EJECT button on VCR 1, then
press the STOP/EJECT button on VCR 2.
2
VCR 1 will play your tape. Put a prerecorded tape in VCR 1.
• Unauthorized recording of copy-
righted television programs, video
tapes, or other materials may
infringe on the rights of copyright
owners and violate copyright laws.
• The VCR in the figure above is the
VRZ250. If you have the VRZ220,
use a single-plug audio cable to con-
nect the AUDIO OUT Jack on VCR 1
to the AUDIO IN Jack on VCR 2.
Helpful Hints
● Audio and Video cables are not supplied.
R
L
VIDEO
IN OUT
IN OUT
AUDIO
R
L
VIDEO
IN OUT
IN OUT
AUDIO
CH3 CH4
OUT
IN
ANT
CH3 CH4
OUT
IN
ANT
VCR 1
Playing VCR
VCR 2 - Recording VCR
1. Audio cables from AUDIO OUT Jacks
of VCR 1 to AUDIO IN Jacks of VCR 2
2. Video cable from VIDEO OUT Jack
of VCR 1 to VIDEO IN Jack of VCR 2
3. RF coaxial
cable from VCR’s
OUT Jack to TV’s
ANTENNA IN
Jack
The instructions on this page show you how to copy tapes. The illustration uses two VRZ250 VCRs.
Different VCRs may operate differently. To duplicate a tape, make the connections shown, then follow
steps 1 - 7.
VRZ220/250 layout 4/8/99 10:11 PM Page 32