Panasonic WJ-ND400 - Manual (Page 25)

25
Connections
This sections explains how to connect the PC, cameras, and extension units. The types of cables and other hardware depend on how each setup
is done. Before starting installation work, check to make sure you have everything you need.
Connect the PC and the camera to the recorder using a HUB. The recorder is connected to the HUB via a LAN cable (straight). You can connect
the PC and camera using either 1 port or 2 port operation.
Using a HUB for Direct Connection
The PC connects to the camera using the Client PC port on the rear of the recorder.
Camera images input through the client PC port are sent to the PC from the same client PC port.
Connecting the PC and the Camera
Important:
• Use a LAN straight cable to connect the recorder and PCs via a hub.
• Do not use a LAN cross cable to connect the recorder and PCs. Using a LAN cross cable for continuous operation may result in incorrect
display and playback because depending on the type of PC transmission may not be steady.
Connectivity Advantages Ports Used
1-port
Operation Used when the PC and camera are on the same network and they directly access
each other without passing through the recorder. Client PC port
2-port
Operation Used when the PC and camera are on different networks and the PC cannot access
the camera directly. Camera port
Client PC port
1 Port Operation
PC
LAN cable
(Not provided: 10BASE-T /
100BASE-TX / 1 000BASE-T
category 5e, straight (NTSC model) /
category 7, straight (PAL model))
PC
Recorder
Network camera
HUB
ND400_Basic.book 25 ページ ２００８年４月８日 火曜日 午後３時５９分