Panasonic WJ-ND400 - Manual (Page 44)

Using the Front Panel for Operations
44
Use the HDD canister provided to install the HDD.
The HDDs can be easily installed or removed from the HDD slots
inside the front cover.
Contact your dealer for information on purchasing, installing, and
replacing HDDs.
1
Install the HDD into the special canister and use the four
screws to fasten both sides of the HDD.
The torque for tightening the screws is 0.49 N•m (5 k
gf•cm)
(use a torque driver)
2
Use the two screws to fasten the bottom of the HDD.
The torque for tightening the screws is 0.49 N•m (5 k
gf•cm)
(use a torque driver)
HDD Unit
Important:
• HDDs are precise devices. Before starting work, refer to "Hard
disk drives (page 9)" for information on how to handle HDDs.
Also, note the following precautions.
⋅ Do not subject them to vibration or impact.
⋅ To install HDDs, use a torque driver and tighten the screws
to the specified torque.
⋅ Before touching an HDD, ground yourself against a metal
object to eliminate any static electricity. Always hold the
HDDs by the sides when carrying them.
⋅ Use an anti-static mat and wristband when installing or
replacing HDDs.
⋅ To prevent static electricity, do not touch the parts.
⋅ At the time of purchase, the HDD unit and canisters are
packaged in exclusive cushion.
The HDD units and canisters may be damaged by fall or
vibration. When transporting the unit, remove these parts
from the unit and package again.
HDD Canister HDD
Anti-static mat
HDD fixing screws for HDD canister
HDD fixing screws for HDD canister
HDD fixing screws for HDD canister
chap3.fm 44 ページ ２００８年４月８日 火曜日 午後５時２１分