Panasonic WJ-ND400 - Manual (Page 34)

About Connectors
34
When settings menu - [Basic] - [Time & date] - [Auto adjustment time] is set to [Slave]
[Time Adjust Input] is available and the time on the recorder is synchronized with the other devices.
15 minutes before or after the set [Activation time] if a signal output from another device is input to the Adjustment Time I/O, the time on the
recorder is set to the [Activation time].
Example:
When the [Activation time] is set to 15:00
• A signal is received at 2:50:00 pm → Set to 3:00:00 pm
• A signal is received at 3:14:45 pm → Set to 3:00:00 pm
• A signal is received at 3:20:00 pm → Time is not adjusted.
Connecting alarm equipment like the buzzer and indicator to pins 15 to 18 sounds the buzzer, lights the indicator and indicates operating status
when a signal is output.
An example of HDD error output (pin 16) is shown below.
Auto Adjustment Time Function Connection 2
Important:
• When [Auto adjustment time] is set to [Slave], time adjustment is not performed during emergency recording and event recording.
Connectivity for Control Output
20 13
(Signal ground)
(Time adjustment input)
ALARM/CONTROL
Front panel
LED monitor
output
Ser
ies recording o
u
tp
u
t
Time adj
u
stment o
u
tp
u
t
T
emper
at
u
re w
ar
ning o
u
tp
u
t
System error o
u
tp
u
t
B
u
zz
er o
u
tp
u
t
Disk Recording Alar
m recording
Alar
m restore o
u
tp
u
t
Alar
m o
u
tp
u
t
Signal g
ro
u
nd
Time adj
u
stment inp
u
t
Ser
ies recording inp
u
t
Alar
m reset inp
u
t
Alar
m Inp
u
t
Sensor inp
u
t
Signal g
ro
u
nd
Terminal for other devices
16 13
(HDD error output)
(Signal ground)
Alarm equipment
ALARM/CONTROL *Attached when necessary.
Relays etc.*
ND400_Basic.book 34 ページ ２００８年４月８日 火曜日 午後３時５９分