Panasonic PV-D4744S - Manual (Page 55)

55
*Important: If a remote control button does not work when pressed,
press the DVD button on the remote and try the button again.
PROGRESSIVE OUT (DVD only)
SET
ACTION
SELECT
PROGRESSIVE OUT
1
Press
to select “PROGRESSIVE
OUT,” and
press
SET repeatedly
for mode. (See below.)
2
OFF: Progressive scan signal is not output.
ON: Progressive scan signal is output from the
Component Video Output Connector.
Sets the Component Video Output Connector (p. 10, 13)
to output the Progressive scan signal.
3 Press ACTION
to exit this mode.
Press ACTION
to display DVD MAIN MENU.
• If the television is not progressive compatible,
a progressive scan picture is not available.
Connect the Video Output or S-Video Output
connector (see p. 12, 13) and set PROGRESSIVE
OUT to “OFF”.
• CONSUMERS SHOULD NOTE THAT NOT ALL
HIGH DEFINITION TELEVISION SETS ARE FULLY
COMPATIBLE WITH THIS PRODUCT AND MAY
CAUSE ARTIFACTS TO BE DISPLAYED IN THE
PICTURE. IN CASE OF 525 PROGRESSIVE SCAN
PICTURE PROBLEMS, IT IS RECOMMENDED
TO SET PROGRESSIVE OUT TO “OFF”.
IF THERE ARE QUESTIONS REGARDING OUR TV
SET COMPATIBILITY WITH THIS MODEL 525p
DVD/VCR DECK, PLEASE CONTACT OUR
CUSTOMER SERVICE CENTER.
DVD MAIN MENU
SELECT :
SET : SET
END : ACT I ON
D I SC LANGUAGES
AUDIO OUTPUT
ST I L L MODE
: AUTO
TV MODE : 4 : 3 P a n & S c a n
PROGRESSIVE OUT : OFF
DVD
Operation
Notes
PV-D4744S P36-72 (040202).p65 2004/02/02, 13:21 55