Panasonic PT-D12000U - Manual (Page 63)

ENGLISH – 63
Basic Operation
OFF: •
Geometry correction is not performed.
KEYSTONE: •
This adjusts projected images when they are
distorted to a trapezoid.
CURVED: •
This adjusts projected images when they are
distorted to a curved surface.
PC: •
This is for performing geometry correction from a PC.
Select “KEYSTONE” or 3.
“CURVED” in Step 2, and then
press ENTER.
The “GEOMETRY:KEYSTONE” or •
“GEOMETRY:CURVED” screen will be
displayed.
GEOMETRY:KEYSTONE
VERTICAL KEYSTONE
VERTICAL SUB KEYSTONE
0
0
GEOMETRY:CURVED
LENS THROW RATIO
VERTICAL KEYSTONE
0
0
Press
▲▼ to select the desired
4.
adjustment item, and press
◄►
to adjust the correction amount.
You can adjust the projection images as shown •
below.
KEYSTONE menu:
VERTICAL KEYSTONE •
VERTICAL SUB KEYSTONE •
HORIZONTAL KEYSTONE •
HORIZONTAL SUB KEYSTONE •
LINEARITY •
CURVED menu:
LENS THROW RATIO •
Set to the throw ratio being used (the
projection distance divided by the screen
width). (pp. 22-24)
VERTICAL KEYSTONE •
HORIZONTAL KEYSTONE •
VERTICAL ARC •
HORIZONTAL ARC •
VERTICAL BALANCE •
HORIZONTAL BALANCE •
Note
If vertical keystone correction is set, menus and logos •
may be projected outside of the actual image area.
If both edge blending adjustment and geometry •
correction are used, set the geometry correction
to curved-surface correction or PC. If geometry
correction is set to keystone-distortion correction,
edge blending adjustment cannot be made
correctly. (p. 66)