Printronix SL5000e - Manual (Page 32)

Chapter 2 RFID PGL Commands
32
END
~EXECUTE;SGTIN–64;ICNT1500
~IDF1;STEP+1;*0*
~IAF1;<DF2>
~NORMAL
NOTE: 1. The <IDF1> usage does not increment the DF1 field. It
merges the DF1 content into the AF1 field, keeping the
same representation previously defined for IDF1.
2. The use of IAF1 is to print alpha on every label. If AF1 is
used instead, only the first label is printed. The AF1 field is
not incremented either since it is using the result from the
DF1 merge.
VERIFY
Purpose Request the printer to send to the host the ASCII
representation of a dynamic field. The dynamic field
could be one of AFn, BFn, or DFn, but cannot be RFn.
Mode CREATE
Format VERIFY;field; format;(D)ASCIIheader(D)
VERIFY The command to verify data of a dynamic
field, enter VERIFY;
field The dynamic field AFn, BFn, or DFn that
contains the data to be sent to the host.
format A letter specifying the format of the
outgoing data to be sent to the host.
B – binary, D – decimal, H –
hexadecimal, S – string
Based on the incoming format of the data
field, a format conversion may be
performed if the outgoing format is not
the same. The AFn and BFn format is
always S type. The DFn format could be
either B, D, or H. Due to the possible
conversion the outgoing data stream
could be longer than the incoming one.